欢迎光临济南大黄蜂工程机械有限公司

热门关键词:

  • 移动碎石机租赁
  • 圆锥碎石机租赁
  • 反击破碎机租赁
当前位置: 首页 - 新闻中心 >
山东大黄蜂工程机械有限公司
电    话:18366127778
地    址:济南市槐荫区经一路273号群盛华城2号楼1-404
网    址:http://www.dhfjx.cn
新闻中心
反击式破碎机遇到故障的解决方案!
网址:http://www.dhfjx.cn    发布时间:2020-06-04
  使用“石头袭击铁”的原则,反击式破碎机适用于破碎的不同的材料规格,不仅破碎比大,而且单位功耗很低,完全符合工艺要求的“多坏了,少穿”,并广泛应用于矿山生产。但是,反攻的工作环境比较苛刻,经过长时间的操作,难免会出现失败。一旦出现故障停机,将直接延误石料堆场建设工期,造成巨大损失。但是,如果你熟悉反攻的常见故障和解决方案,你可以很快找到原因和解决方案,迅速恢复正常生产,减少损失。
  Using the principle of "stone attacks iron", the impact crusher is suitable for crushing different material specifications, not only the crushing ratio is large, but also the unit power consumption is very low, fully in line with the process requirements of "more bad, less wear", and widely used in mine production. However, the working environment of the counter offensive is relatively harsh, and after a long time of operation, failure will inevitably occur. In case of failure and shutdown, the construction period of stone yard will be directly delayed, resulting in huge losses. However, if you are familiar with the common faults and solutions of the counter attack, you can quickly find the causes and solutions, quickly resume normal production and reduce losses.
  今天,山多重工将带您了解反击式破碎机常见的十大故障及解决方案,希望对您有所帮助。
  Today, SDIC will show you ten common faults and solutions of impact crusher, hoping to help you.
  1、反击破坏启动装置,不工作
  1. Counterattack damages the starting device, does not work
  检查给料机前物料是否因停止振动而落入破碎室,造成物料堵塞转子。破碎室内的物料需要清理,重新启动即可解决。
  Check whether the materials in front of the feeder fall into the crushing chamber due to the stop of vibration, causing the materials to block the rotor. The materials in the crushing chamber need to be cleaned up, which can be solved by restarting.
  二、反击断轴承发热
移动碎石机租赁
  2、 Reaction broken bearing heating
  检查轴承是否润滑良好。正常情况下,润滑油应注满轴承座体积的50%。另一种情况是润滑油变质、粘稠,需要清洗轴承,更换新的润滑油。
  Check whether the bearing is well lubricated. Under normal conditions, the lubricating oil shall be filled up to 50% of the volume of bearing pedestal. Another situation is that the lubricating oil is deteriorated and viscous. It is necessary to clean the bearing and replace the new lubricating oil.
  三世。设备异常振动
  III. Abnormal vibration of equipment
  可能的原因和解决办法是:
  The possible causes and solutions are:
  1. 进食量可能过大;
  1. The food intake may be too large;
  2. 耐磨件磨损不均匀,反击锤头需要更换;
  2. The wear-resistant parts are not evenly worn, and the impact hammer head needs to be replaced;
  3、转子不平衡,需要调整、校正平衡;
  3. The rotor is unbalanced, which needs to be adjusted and corrected;
  4. 检查设备地脚螺栓是否紧固、加固。
  4. Check whether the anchor bolts of the equipment are tightened and reinforced.
  四、反攻断带翻转
  4、 Counterattack broken belt turning
  主要由于皮带损坏,应更换皮带,注意保证皮带的质量;或者由于滑轮装配不当,需要将主动轮和从动轮调整在同一平面上。
  The belt shall be replaced mainly due to the damage of the belt, and the quality of the belt shall be ensured; or the driving wheel and driven wheel shall be adjusted on the same plane due to the improper assembly of the pulley.
  机器轴承弯曲或损坏
  Bent or damaged machine bearings
  主要原因是主机长期超负荷运转,轴承热处理不当,断裂材料硬度超标。搬运时,有必要更换新的轴承,并在以后的操作过程中注意及时维修保养。
  The main reason is that the main engine is overloaded for a long time, the bearing heat treatment is improper, and the hardness of fracture material exceeds the standard. When carrying, it is necessary to replace the new bearing, and pay attention to timely maintenance in the later operation process.
  以上就是移动碎石机租赁对反击破碎机常见故障的解决措施的详细介绍,想要了解更多请点击官网http://www.dhfjx.cn
  The above is a detailed introduction of the solutions for common faults of the impact crusher by mobile crusher leasing. For more information, please click http://www.dhfjx.cn
上一条:反击碎石机相对于锤式碎石机有哪...        下一条:反击破碎机的构造及工作原理

创新驱动发展,科技引领未来,诚信铸就品牌

地址:济南市槐荫区经一路273号群盛华城2号楼1-404  电话:18366127778

山东大黄蜂工程机械有限公司      流量分析: