欢迎光临济南大黄蜂工程机械有限公司

热门关键词:

  • 移动碎石机租赁
  • 圆锥碎石机租赁
  • 反击破碎机租赁
当前位置: 首页 - 新闻中心 >
山东大黄蜂工程机械有限公司
电    话:18366127778
地    址:济南市槐荫区经一路273号群盛华城2号楼1-404
网    址:http://www.dhfjx.cn
新闻中心
移动碎石机怎么确保更好的运作效率?
网址:http://www.dhfjx.cn    发布时间:2020-01-07
  1. 日常维护
  1. Daily maintenance
  设备应根据要求,润滑中小设备主要润滑脂和润滑油定期润滑。在大型设备,如果使用锥形和大型颚式破碎机,通常有强制润滑系统。这时,应经常注意观察油温、油压、流量等参数。已经松动的紧固件
  Equipment shall be lubricated regularly with main grease and lubricating oil for small and medium-sized equipment according to requirements. In large equipment, if cone and large jaw crushers are used, there is usually a forced lubrication system. At this time, pay attention to the oil temperature, oil pressure, flow and other parameters. Loose fasteners
  在设备运行过程中,要注意设备的噪声和振动。如果噪音或震动过大,应尽快停机检查。故障排除后,按开机顺序进行空载重启
  During the operation of the equipment, pay attention to the noise and vibration of the equipment. If there is too much noise or vibration, stop the machine for inspection as soon as possible. After troubleshooting, restart at no load according to the starting sequence
  在设备运行过程中,还要注意观察产品的质量、生产率,当质量和生产率不正常时,可能会出现破碎机、筛块或筛面损坏故障
  During the operation of the equipment, pay attention to observe the quality and productivity of the product. When the quality and productivity are not normal, the crusher, screen block or screen surface may be damaged
  2、检修
  2, overhaul
  为了使设备保持良好的性能,除正常维护外,还应定期对设备进行小修、中修和大修。
  In order to maintain good performance of the equipment, in addition to normal maintenance, minor repair, medium repair and overhaul should be carried out regularly.
移动碎石机租赁
  1)小修
  1) minor repairs
  它是计划维修的主要形式,其目的是消除设备在使用过程中零部件的磨损所造成的局部损伤的影响,调整或更换部分零部件,使设备恢复正常运行。有时也进行预检查,为下一次小修、中修或大修做准备。
  It is the main form of planned maintenance. Its purpose is to eliminate the impact of local damage caused by the wear of parts during the use of the equipment, adjust or replace some parts, and make the equipment return to normal operation. Sometimes pre inspection is also carried out to prepare for the next minor repair, medium repair or major repair.
  2)中修
  2) medium repair
  它是当设备停止运行时所进行的维护工作。其目的是详细检查设备的重要部件,更换一些部件,解决各部件的使用寿命不协调的问题。在中修过程中,经常要拆解整个机组,清洗部件,检查各部件的磨损情况。
  It is the maintenance work when the equipment stops running. Its purpose is to check the important parts of the equipment in detail, replace some parts, and solve the problem of uncoordinated service life of each part. In the process of intermediate repair, it is often necessary to disassemble the whole unit, clean the components and check the wear of each component.
  3)大修
  3) overhaul
  是设备长时间不能使用时所进行的维护工作。大修期间,所有部件必须拆卸并仔细检查。维修和更新所有部件,使设备完全恢复正常状态和工作能力。大修包括小修和中修。此外,还应更换已达到使用寿命的大型部件。
  It is the maintenance work when the equipment cannot be used for a long time. During overhaul, all components must be disassembled and inspected carefully. Repair and update all parts to make the equipment fully return to normal state and working capacity. Major repair includes minor repair and medium repair. In addition, large components that have reached the service life should be replaced.
  在维修方法上,部件预焊方法较好。该方法是在设备运行条件下进行的。由于提前准备好了完整的零件,维修时间大大缩短。部分维修是在设备关闭后进行的。
  In the maintenance method, the component pre welding method is better. This method is carried out under the condition of equipment operation. Due to the complete parts prepared in advance, the maintenance time is greatly shortened. Part of the maintenance is carried out after the equipment is shut down.
  以上就是移动碎石机租赁对移动碎石机维修的详细介绍,想要了解更多请点击官网http://www.dhfjx.cn
  The above is the detailed introduction of mobile lithotripter rental to the maintenance of mobile lithotripter. For more information, please click http://www.dhfjx.cn
上一条:移动碎石机租赁行业现状怎么样?        下一条:反击式破碎技术特点都体现哪些方面?

创新驱动发展,科技引领未来,诚信铸就品牌

地址:济南市槐荫区经一路273号群盛华城2号楼1-404  电话:18366127778

山东大黄蜂工程机械有限公司      流量分析: