欢迎光临济南大黄蜂工程机械有限公司

热门关键词:

  • 移动碎石机租赁
  • 圆锥碎石机租赁
  • 反击破碎机租赁
当前位置: 首页 - 新闻中心 >
山东大黄蜂工程机械有限公司
电    话:18366127778
地    址:济南市槐荫区经一路273号群盛华城2号楼1-404
网    址:http://www.dhfjx.cn
新闻中心
怎么解决移动碎石机使用过程中的突发事件?
网址:http://www.dhfjx.cn    发布时间:2019-11-26
在使用移动碎石机租赁的时候更怕遇到移动碎石机有突发事件,但是难免会遇到,那么现在就由济南大黄蜂工程机械有限公司带大家了解一下我们在使用移动碎石机租赁经常遇见的突发事件及解决方法都有哪些?
  When using mobile lithotripter leasing, we are most afraid of encountering emergencies of mobile lithotripter, but we will inevitably encounter them. Now, Jinan Bumblebee Construction Machinery Co., Ltd. will take you to know what emergencies and solutions we often encounter when using mobile lithotripter leasing?
  一、移动破碎机主机突然停机。
  I. The main machine of mobile crusher stops suddenly.
  1、排料口堵塞,造成满腔堵料。
  1. The discharge port is blocked, causing full cavity blocking.
  2、驱动槽轮转动的三角皮带过松,造成皮带打滑。
  2. The V-belt rotated by the driving sheave is too loose, causing the belt to slip.
  3、偏心轴紧定衬套松动,造成机架的轴承座内两边无间隙,使偏心轴卡死,无法转动。
  3. The fastening bush of the eccentric shaft is loose, which causes no gap between the two sides of the bearing seat of the frame, so that the eccentric shaft is stuck and cannot rotate.
  4、工作场地电压过低,主机遇到大料后,无力破碎。
  4. The voltage of the working site is too low, and the main engine cannot be broken after encountering large materials.
  5、轴承损坏。
  5. The bearing is damaged.
  针对以上的这些情况可以采取:清除排料口堵塞物,确保出料畅通,调紧或更换三角皮带,重新安装或更换紧定衬套,调正工作场地的电压,使之符合主机工作电压的要求,更换轴承等办法解决这些情况。
  In view of the above situations, the following measures can be taken: removing the blockage at the discharge port, ensuring the smooth discharge, tightening or replacing the V-belt, reinstalling or replacing the tightening bush, adjusting the voltage of the working site to meet the requirements of the working voltage of the main engine, replacing the bearing, etc.
  二、移动破碎机主机槽轮、动颚运转正常,但破碎工作停止的原因有:拉紧弹簧断裂,拉杆断裂,肘板脱落或断裂。
  II. The slot wheel and movable jaw of the main machine of the mobile crusher operate normally, but the reasons for stopping the crushing work are: the tension spring is broken, the pull rod is broken, and the bracket plate is dropped or broken.
  排除方法是更换拉紧弹簧,更换拉杆,重新安装或更换肘板。
  The solution is to replace the tension spring, the pull rod, and the bracket.
  三、肘板断裂
  III. fracture of elbow plate
  1、主机超负荷或大于进料口尺寸的料进入。
  1. The main machine is overloaded or the material larger than the size of the feed inlet enters.
  2、有非破碎物进入破碎腔。
  2. There are non broken objects entering the crushing chamber.
  3、肘板与肘板垫之间不平行,有偏斜。
  3. The elbow plate and the elbow plate pad are not parallel and skew.
  4、铸件有较严重的铸造缺陷。
  4. The casting has serious casting defects.
移动碎石机租赁
  解决办法:
  terms of settlement:
  1、更换移动破碎机肘板并控制进料粒度,并防止主机超负荷
  1. Replace the mobile crusher bracket and control the feeding granularity, and prevent the main machine from overload
  2、更换肘板并采取措施,防止非破碎物进入破碎腔
  2. Replace the bracket and take measures to prevent the non broken materials from entering the crushing chamber
  3、更换肘板并更换已磨损的肘板垫,正确安装肘板
  3. Replace the elbow plate and replace the worn elbow plate pad, and install the elbow plate correctly
  4、更换合格的肘板。
  4. Replace the qualified elbow plate.
  以上就是由济南大黄蜂工程机械有限公司带大家了解的使用移动碎石机租赁经常遇见的突发事件及解决方法的介绍!希望可以帮到你,想要了解更多请点击官网http://www.dhfjx.cn
  The above is by Jinan Bumblebee Construction Machinery Co., Ltd. with you to understand the use of mobile lithotripter rental often encountered emergencies and solutions! I hope I can help you. To learn more, please click http://www.dhfjx.cn
上一条:移动碎石机哪些方面成为它发展的...        下一条:移动碎石机在恶劣环境中的优势?

创新驱动发展,科技引领未来,诚信铸就品牌

地址:济南市槐荫区经一路273号群盛华城2号楼1-404  电话:18366127778

CopyRight © 2018. 山东大黄蜂工程机械有限公司 All Rights Reserved.   技术支持: 济南诺商  
备案号:鲁ICP备17031054号-1  流量分析: